Cane Crono Guida Utente Scaricare il pdf (Pagina 28)

MAN 01/EN/03 CRONO PAR 50 06/13

SECTION 7

The displayed error messages (from Er,1 to Er,11 and OCCL) are accompa-

nied by an acoustic signal and the system stops.

• Following the display of error message Er,1 in the:

- ON condition (Auto version) after you press the

button, the pump recom-

mences the delivery of the drug, but only using the lowest of the programmed

ow rates;

- OFF condition, after you press the

button, the pump will be set back to

OFF;

- Battery insertion condition, after you press the

button, the pump will be

initialised (as described on page 30).

• The display will show the clock icon and the ashing dashes on the two

secondary digits until the time is reset.

• It is necessary to reset the hours and minutes by accessing the settings as

described in the “PUMP SETTINGS SEQUENCE” section on pages 38 and 59.

• If at the time when Er,1 is signalled the hourly ow value is set to F0, the

pump will NOT administer the drug until it is switched off and on again.

• If the time is not reset, every time the pump starts or resumes an infusion,

it will signal Er,1 and administer the drug for the whole delivery time at the

minimum ow among the 3 set values.

• In the event that it is not possible to reset the time from the settings menu of

the pump, contact the CANÈ S.p.A. Technical Support Service.

• Error messages Er,2 and Er,7 are accompanied by the ashing red LED.

• Following the display of error message Er,8 and the successive initialisation,

the system re-imposes the factory settings in FrEE mode (see pages 32 and

53): in this event the pump settings prescribed by the doctor should be re-

entered.

• The settings prescribed by the doctor must be noted on a copy of the patient

settings record sheet on page 110 or the notes sheet on page 113.

WARNINGS

NOTE

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 113 114

Nessun commento

Cane Crono Guida Utente Pagina 28